UHWS - Unvented Hot Water Assessment only - initial

This assessment will cover the following:

Install and Commission Appliances

• Check the performance of the incoming water supply
• Inspecting the installation for compliance
• Commissioning the installation in accordance with manufacturers instructions
• Identifying defects
• Operating all safety controls
• Recording results

Service Appliance

• Inspecting the installation for compliance
• Checking the flow rate and pressure
• Servicing the installation in accordance with manufacturers instruction
• Recording results

No formal entry requirements but you should be competent in hot & cold water system installations.

Competency to enter this course will be considered based on you either having completed a relevant NVQ qualification such as plumbing, heating & ventilation or gas, or having been working in the industry for approximately two years in these areas with relevant technical certificates.

If you are concerned that you do not fit this criteria please contact us to discuss your circumstances and consider the Inital training and assessment course.

Assessment is based on 3 theory tests and a practical assessment.

Also please refer to Additional information below.

On successful completion of this course you can progress onto Water Regulations or Energy Efficiency.

It should be noted that a study pack and workbook will be provided prior to starting the assessment.

The workbook will require certain aspects being completed prior to attending the course which will be outlined within the joining instructions.

For Course booking and further details please contact Gas Booking Centre on 01202 205712.

Awarding Body:
BPEC

Curriculum Area:
Construction - Building Services